Skip to main content

03-PrintingButterBot

Since this project is relatively large, I needed to break the printing up into several print jobs. The spotlight itself was printed in two parts–main body and leaves (8.5 hrs, 14 hrs). The ButterBot was broken up into prints consisting of the base (not pictured, 4 hrs), arms (6 hrs), main body + treads (10.5 hrs), and head (18 hrs), for a grand total of 61 hours of print time and roughly 400 grams (almost half a roll) of filament.

Leave a Reply

Your email address will not be published. Required fields are marked *